Local contractor in 38122

A blockage under the kitchen sink was causing significant drainage issues. We utilized a drill auger to effectively clear the obstruction, successfully dislodging a penny stuck in the garbage disposal, restoring the sink's functionality.

The air conditioning system was not achieving the desired cooling, leading to discomfort. We checked the clean filter and condenser, cycled the AC, and identified low freon levels. After adding 3 lbs of 410a refrigerant and incorporating leak stop with UV dye, the system is now functioning properly and effectively cooling the space.

The air conditioning system was not performing optimally due to a malfunctioning condenser fan motor and capacitor. We replaced both components, restoring the system's functionality. The unit is now operating normally, providing effective cooling once again.

The back system was not operational, indicating a potential 24v issue. We cleaned the package unit thoroughly and diagnosed the underlying problem to ensure proper functionality for the residential HVAC system. After addressing the electrical concerns, the system was restored to optimal performance.

The old 2-ton HVAC system was inefficient and required an upgrade. We installed a new 2-ton system featuring a furnace, A-coil, condenser, supply plenum, emergency drain pan, and safety switches. Ductwork was reconnected, and a new vent pipe was installed through the roof. After replacing the thermostat and filter, we addressed low system pressures by adding 0.5 lb of R32 refrigerant to ensure optimal cooling performance.

We replaced the hot and cold Gerber stems in the hall bathroom shower to resolve issues with temperature regulation.

We ran a switchback from the roof of the house, pulled the toilet to run a big auger machine after clearing a blockage, and replaced a section of the kitchen drain underneath the house.

We replaced the whole 2.5 ton system for a residential customer, including slip and vent installation. We ensured the new system fit the space constraints in the attic by selecting an Ameristar unit due to its height. The customer opted for a 10-year parts and labor warranty.

Heat not working due to locked up blower motor. Replaced blower motor and cleaned blower wheel. Cycled heat again and mercury bulb in thermostat was not making a good connection and you had to fiddle with it to get it to come on. Owner wanted it replaced as well. Heat is working at this time.